AMA KE 6002-2, Оригинальное руководство по эксплуатации

Страница: 48 / 90

6.4 Installing the universal joint shaft on the implement
IMPORTANT
Damage when the universal joint shaft is
too long
To avoid damage to the implement,
check the universal joint shaft length
every time the tractor is changed.
If the universal joint shaft is too long,
have the universal joint shaft corrected by
a qualified specialist workshop.
1. Clean and grease the drive shaft on the
implement.
2. Make sure that the universal joint shaft guard is
functional.
The tractor symbol on the guard tube identifies the
tractor-side of the universal joint shaft. An existing
overload clutch or freewheel clutch must be installed
on the implement side.
3. Slide the universal joint shaft
1
onto the
gearbox output shaft
3
.
4.
To secure the universal joint shaft on the
gearbox,
tighten the locking bolt on the universal joint
shaft with the tightening torque prescribed by the
universal joint shaft manufacturer.
5. Lift the bracket
2
out of the holder.
6. Swivel the bracket under the universal joint shaft.
7. Put the universal joint shaft in the bracket.
8. Secure the guard tube with the safety chain on
the fastening point
4
.
1 2
4
3
CMS-I-00006826
CMS-T-00010034-A.1
6 | Preparing the machine
Installing the universal joint shaft on the implement
MG7512-EN-GB | C.1 | 29.09.2022 | © AMAZONE 44