5
6) Lengthen or shorten the stem, so when you stand upright with the detector in your
hand, the search coil is level with and about 5-2 inches / 1-5 cm above the ground. After
that tighten the lock nut.
CAUTION:
•
The search coil’s plug fits into the connector only one way. Do not force the plug
or you could damage it.
•
Do not disassemble the stem lock nut. In case you disassemble it, place the
washer on the top of the stem connected with the handle with the small head of
the washer upwards. Then hitch the stem lock nut on the washer then tighten it
to lock it in place.
Adjusting the search coil
Loosen the knobs at the search coil’s end, adjust the search coil to the desired angle.
(The search coil should be parallel with the ground.) Tighten the knobs just enough to
keep the search coil from rotating or wobbling.
Installing batteries
1) Turn off the power before installing the batteries.
2) Press on the battery compartment cover and slide the cover off in the direction of the
arrow.
3) Connect the battery with the battery connector taking care of the polarity. Then put
the battery into the compartment.
4) Replace the cover.