Alvarion BreezeACCESS SU-A-EZ, Руководство по эксплуатации продукта

Страница: 133 / 165

Chapter 5 - Command Line Interface Wireless Commands
BreezeACCESS SU-A-EZ 116 Product Manual
Default Setting
00:00:00:00:00:00
Command Mode
Installer, Admin
Example
5.10.15 set ClientSta bandwidth
This command sets the channel banwidth(s) that the unit may use to associate to
an AU.
Syntax
set ClientSta bandwidth < 10 | 20 | 10-20 >
• 10 - The unit can use 10 MHz channels.
• 20 - The unit can use 20 MHz channels.
• 10-20 - The unit can use either 10 or 20 MHz channels.
Default Setting
10-20
Command Mode
Installer, Admin
Example
5.10.16 get BSSList
This command shows all 802.11a wireless devices that act as AP’s (transmit
beacons) within the proximity of the SU-A-EZ.
Syntax
get BSSList
get BSSList < essid | apmac | channel | freq | rssi >
• essid - The service set identifier that is attached to packets sent from neighboring
devices.
• apmac - The physical layer address used to uniquely identify the APs.
• channel - The radio channel through which neighboring devices communicate with the
SU-A-EZ.
• freq - The frequency on which neighboring devices are transmitting (this applies only
for 20MHz bandwidth OFDM signals.)
• rssi - A measure of the signal strength received from neighboring devices.
Installer# set ClientSta PreferredAuMacAddress 24:13:96:74:88:50
Installer#
Installer# set ClientSta bandwidth 10
Installer#