Alvarion BreezeACCESS EZ AU-EZ, Системное руководство

Страница: 39 / 175

Chapter 2 - Installation Installing the Outdoor Unit
BreezeACCESS EZ AU-EZ 20 System Manual
2.3.3 Connecting the Grounding and Antenna
Cables
The Grounding screw (marked ) is located on the bottom panel of the outdoor
unit. The Antenna RF connector (marked ) is located on the top panel of the
ODU.
1
Connect one end of a grounding cable to the grounding terminal and tighten
the grounding screw firmly.
2
Connect the other end of the grounding cable to a good ground (earth)
connection.
1
Connect one end of the coaxial RF cable to the RF connector on the top panel
of the unit
2
Connect the other end of the RF cable to the antenna.
3 The RF connectors should be properly sealed to protect against rain and
moisture.
To connect the grounding cable:
To connect the RF cable:
Figure 2-3: Bottom Panel of the ODU (shown without the sealing assembly)
NOTE
The MAC Address of the unit is marked on both the ODU and the indoor unit (on the bottom side of
the Universal IDU). If for any reason the ODU is not used with the IDU with which it was shipped,
the MAC Address of the system is in accordance with the marking on the ODU.