Alutech LG-500, Руководство по сборке и эксплуатации

Страница: 77 / 82

ПРИВОД LG-500 | LG-500 DRIVE)
75
TROUBLESHOOTING
Regularly check the drive system. In particular, check cables, springs and mounting hardware,
for the signs of wear, damage or imbalance. It is prohibited to use a door requiring repair or
adjustment, as the mounting defect or incorrect balance of the door may result in injury or
product failure.
Perform scheduled maintenance of the drive system to ensure efficient and safe operation.
Scheduled maintenance shall strictly comply with the existing regulatory documents, instructions
in this manual, instructions for other involved devices, and following the safety rules. Perform
scheduled maintenance at least once every six months.
Scheduled maintenance shall include:
• check the wear of the set elements, paying attention to oxidization of the components.
Replace all parts and units with an unacceptable degree of wear. Use original parts from the
manufacturer.
• Check the correctness of the door stop in its final positions. If necessary, reprogram the final
positions.
• Clean external surfaces of the drive and safety devices. Clean with the help of a soft moist
cloth. The use of the following for cleaning is forbidden: water jets, high pressure cleaners,
acids and alkali.
• Perform the check according to the instruction in section 7. ‘Testing and commissioning’.
The service life of the product is 8 years with the intensity of work of 10 cycles of ‘opening-closing’
of the gate per day.
Y
ATTENTION! The manufacturer does not perform direct control of the mounting of the door,
drive and automation devices, their maintenance and operation, and cannot be responsible for
the safety of the drive system mounting, operation and maintenance.
9. TROUBLESHOOTING
Y
ATTENTION!
In case of a failure, which cannot be repaired, based on the information provided
in this manual, consult the service department. Information about the service department can
be obtained from your supplier (vendor, installation company).
FAULT POSSIBLE REASON RECOMMENDATIONS
Drive does not work
(ALUTECH logo on the drive
is not lit; display does not react,
when buttons on the front plate
are pressed)
No supply voltage or fuse
is blown
Check the supply voltage.
Check, and if necessary, replace
the fuse (fuse parameters should
comply with the marking)
Drive is not controlled by the
remote control (indicator on the
control is not lit)
Remote control code is not
recorded in the drive control
unit memory
Record the remote control in the
drive memory
Drive is not controlled by the
remote control or the distance
of the remote-control operation
is small
Low battery in remote
control
Check the remote-control battery
and replace, if necessary
Drive works after a command,
but the door does not move
The drive rail carriage is not
blocked
Block the drive rail carriage
Table 16