Alutech LG-500, Руководство по сборке и эксплуатации

Страница: 76 / 82

ПРИВОД LG-500 | LG-500 DRIVE)
74
OPERATION
• Make sure that the integrated LED backlight is functioning. It is active when the door is moving
and for a set time after the door stops.
• Check the correct working of the connected control devices (control buttons, remote controls).
• Check the correct working of each connected safety and alarm device (photocells, movement
stop devices, lamps etc.). Check the photocells for the absence of interaction with other
devices, to do so—close the optical axis: first close to TX-photocell (transmitter), then close to
RX-photocell (receiver) and then in the middle, between the two photocells. Make sure that in
all cases the drive properly reacts to the activation of photocells (during closing the door stops
and then fully opens).
• Check the ability of the drive to identify the interaction with foreign objects during closing.
Put a 50 mm high obstacle on the floor. When the door contacts the obstacle during door
closing, the drive should stop the door and open completely. If required, adjust the force
(section 6 ‘Adjustment
P5
–
F2
’). The specialist shall check the system for compliance with the
safety standard (EN 12453).
Commissioning of the drive system can be done only after successful completion of tests. Partial
commissioning or temporary operation are forbidden.
Commissioning requires the installer to:
• prepare and keep technical documentation for the automation set. The documentation
shall include: general drawing, circuit layout, assembly and operation manual, as well as
maintenance schedule.
• Fasten a permanent sticker or a sign next to the door with the description of unblocking and
manual opening of the door.
• Fasten a permanent safety sticker next to the door in a visible place, containing the instruction
with the following meaning: ‘ Attention! Automatic drive . Do not stand close to the door
because of the possibility of unexpected activation . Children are not allowed to stand
near the door during its movement ’.
• Fasten next to the door or to the fixed control units in a visible place, stickers with a warning
about possible jamming with the following meaning: ‘Attention ! Jamming risk ! Regularly check
and regulate, if necessary, so that in case of contact of the door leaf with a 50 mm high object,
placed on the floor, the direction of the leaf movement changed to the opposite direction,
or such subject could be freed’.
• Pass the filled ‘Assembly and operation manual’ to the user (owner).
• Prepare the ‘Maintenance schedule’ and give it to the user (owner).
Instruct about maintenance rules.
• Instruct the owner about the existing hazards and risks, and inform about safe operation rules.
Explain to the owner the need to inform the persons operating the door about the existing
hazards and risks, and about safe operation rules.
8. OPERATION
Y
ATTENTION! The product shall not be used by children or persons with limited physical, sensory
or mental abilities, as well as persons with insufficient experience and knowledge. Do not let chil-
dren play with control elements. Remote controls shall be stored in areas, unreachable by children.
Do not touch moving door or moving parts. Before starting movement of the door make sure,
that no people, animals, vehicles or objects are in the danger area of the door. Monitor door
movement. Passage of people and vehicles through the moving door is prohibited.
Be careful when using manual unblocking of the door, as an open unblocked door can fall quickly
because of many factors such as slack or broken springs, or the door being poorly balanced.
Check the operation of safety devices every month.