Alutech LG-500, Руководство по сборке и эксплуатации

Страница: 67 / 82

ПРИВОД LG-500 | LG-500 DRIVE)
65
ADjUSTMENT
CONTACT DESCRIPTION
REL− Signal lamp ( SL ) or lighting lamp ( LL ) connection contacts. Output RL + —operating supply
voltage 24 V DC / max 50 mA. If the lamps have other characteristics, it is necessary to use a
coupling relay (not included in the kit) with characteristics relevant for output RL + and chosen
lamp ( fig. 24 ). By default the output set for operation with
SL
(signal) lamp. The output operation
mode can be chosen in settings (section «6. Settings» P8 – F4 )
REL+
6. ADjUSTMENT
The adjustment of the drive is performed using the board with buttons. A display is used for
indication ( fig. 27).
— the button to enter the settings menu and to exit the menu.
—
the button to enter the settings and confirm the selected value.
— the button to move step-by-step to the menu with the zoom; it is also used to
control the opening process when setting the end positions manually.
— the button to move step-by-step to menu with reduction; it is also used to control
the closing process when setting the end positions manually.
6.1 ADjUSTMENT OF THE DOOR POSITION
The end
OPEN
and
CLOSED
positions are set manually (setting
P1
–
F1
) or automatically (ex-
press setup P1 – F3 with a switch to the recording of remote controls). If the end positions are
not set, the drive does not execute a commands, and two dots will appear on the display
.
SETTING P1-F1:
PROGRAMMING THE END POSITIONS MANUALLY
1
Press and hold the button for about 5 secs to enter the
programming mode
2
After the appearance of ‘ P1’ inscription press the button
3
After the appearance of ‘ F1 ’ inscription press the button
4
Using the button or set the door in the OPEN position.
ATTENTION! In the OPEN position the carriage rail should be at a distance
~ 20 mm from the support; installation of support is compulsory ( fig. 16)
5
Press the button ; after that a dot will appear on the display, which
means the
OPEN
position
6
Using the button or set the door in the CLOSED position.
ATTENTION!
Avoid excessive pressing of the door leaf against the doorway
in the CLOSED position. After setting the end positions, the force applied for
manual release should not be more than 220 N (section 4.2. «Manual release»)
Table 5