Alutech LG-500, Руководство по сборке и эксплуатации

Страница: 64 / 82

ПРИВОД LG-500 | LG-500 DRIVE)
62
MOUNTING
Do not perform any electric connections while laying the electric cables. Make sure, that the
cables are isolated and therefore not live.
Prior to mounting:
• determine the place, where each component of the drive system will be installed.
Fig . 2 presents a typical diagram of the garage door automation. Together with the user,
determine the places for the installation of the control devices.
• determine the scheme, according to which all the electric devices of the drive system will be
connected.
• lay the electric cables to the places, where the drive system components are to be installed,
complying with the regulations in force.
• remove unnecessary parts (ropes, angles etc.) and disconnect all the unnecessary equipment.
4. MOUNTING
4.1 DRIVE RAIL AND DRIVE MOUNTING
Recommended mounting procedure:
• determine and mark the mounting line in the middle of the door ( fig . 3). If mounting
cannot be performed in the middle of the door, it acceptable to mount at the distance
not exceeding 100 mm to left or to the right from the middle of the door.
• Install the door bracket using eight 6.3 × 20 screws ( fig . 4). Drill Ø 5 mm holes in the door leaf
metal.
Y
ATTENTION! Limit the drilling depth during drilling. Do not allow through drilling of the door leaf.
• Install the rail fastening bracket on the wall on the drive rail using two M8 × 16 bolts
and two M8 nuts ( fig . 5A). The product construction allows turning of the bracket by 90 °
in relation to the rail during installation ( fig . 5B), e.g., to mount the rail on the ceiling without
suspension strips.
• Mark the rail fastening bracket installation area on the wall ( fig . 6 ). The clearance between the
rail and the maximum (top) spot of the door movement should be 20–50 mm.
• Fasten the rail fastening bracket on the wall ( fig . 7).
Y
ATTENTION!
Fixings (dowels, anchors), required to install the rail, should be selected to comply
with the type of construction surfaces present (material and thickness of the wall or ceiling).
They are not included in the kit. The fittings should be able to bear the weight of the rail with
the drive fitted and resist the force required to open and close the door. Beware of wear and
deformation, which will occur in time.
• Install the brackets, fastening the rail to the ceiling, on the drive rail ( fig . 8).
• Install one bracket at the distance 180 … 220 mm from the rail edge ( fig . 9).
• Install the second bracket in ensuring position which ensures the best stability of the rail.
For example, at 1 / 3 from the door opening ( fig . 10).
• Position (align) the rail in relation to the door construction ( fig . 11). Adjust the position of
the brackets of the rail and determine the necessary distance
L
from the rail to the ceiling
(suspension distance).
• Install suspension strips on the brackets, fastening the rail to the ceiling, and align them
( fig . 12). Fasten the suspension strip on the bracket using two M8 × 16 bolts and two M8 nuts.
• Bend the suspension strip on two sides, preserving the previously measured size
L
and bend
angle ( fig . 13). Fasten the suspension strips on the ceiling using fixings (dowels, anchors).