The Temperature Sensor
is used to detect freeze and
overheat conditions. The sensor will alarm when the
temperature trip points are reached.
Features
• Indicates freeze and overheat warnings
• Industry-leading wireless range and battery life
• Secure encrypted wireless transmissions
• 5-year warranty
Enroll
by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Options for sending an Enrollment Signal
• Remove the battery tab and cover to
trip tamper. Select desired Loop:
• Loop 1: Overheat
• Loop 2: Magnetic reed (magnet
not included)
• Loop 3: Freeze
• Loop 4: Tamper
Install
by mounting the sensor in the desired location
using two #4 or #6 screws. An optional cover-securing
screw is included. Alternatively, the sensor can also be
installed using 3M™ VHB™ tape.
Freeze
or
Heat
alarms
are transmitted when the
temperature trip points are reached.
Temperature Trip Points
• Heat alarms when over 100°F (38°C)
• Heat restores when under 97°F (36°C)
• Freeze alarms when under 45°F (7°C)
• Freeze restores when over 48°F (9°C)
Use the panel installation guide to verify proper system setup.
Mounting Screw Holes
RE205 Temperature Sensor
Honeywell
®
Compatible
IN
STALL
G
U I D E
I
Cover-Securing Screw Hole
Resolution Compatibles
Pro Tips
3M™ VHB™ Tape
works great if the surface is properly prepared and firm pressure is
applied for over 10 seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50°F