LongLife Door/Window Sensor
is a transmitter with a
ten year battery life. Typically used to sense opening and
closings of doors and windows, it will alarm when the
magnet is pulled away from the sensor.
Features
• Ten year battery life
• Quick peel and press mounting
• Secure encrypted wireless transmissions
Enroll
by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Alternatively, the sensor can be enrolled by entering its
8-character serial number in the AlulaConnect™ portal.
Options for sending an Enrollment Signal
• Remove the battery tab, which can be done
without removing the cover, OR
• Remove the cover to trip the tamper
Note:
Slide the cover to open and close
Install
by removing the adhesive paper and adhering
the sensor and magnet on a door or window. Leave a
minimum of 3/16 inch clearance around the ends of the
sensor to allow the cover to open. Make sure to align
the alignment marks on the sensor and magnet when
mounting.
High Bond Tape
works great if the surface is properly
prepared and firm pressure is applied for over 10
seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is
above 50°F
Use the panel installation guide to verify proper system setup.
LongLife Door/Window Sensor
™
Encrypted (DWS-LL)
IN
STALL
G
U I D E
I
Slide to
Open
3/16”
3/16”
