Alula Connect+ RE659 Скачать руководство пользователя страница 1

360 PIR Motion Sensor

 

alarms when motion is sensed.       

It is a commercial battery-powered ceiling mount sensor 

with a 360 degree detection range. 

Features

•  360° detection range with 62 distinct detection zones

•  Range up to 40 feet in diameter

•  Selectable pulse count 2 or 4

•  Designed for commercial applications

•  5 year warranty

Enroll

 by entering the serial number into the security panel. 

Alternatively, the sensor can be enrolled by placing the 

panel into enrollment mode, and then pulling the battery 

tab or tampering the device.

Install

 by screwing two #8 screws into the ceiling, leaving 1/4 

inch of thread exposed. Next, slide the back plate over the 

screws and rotate the back plate. Screw the third #8 screw 

through the wall tamper into the ceiling, ensuring that the 

wall tamper screw is attached to something solid. Tighten 

all screws until snug. Then, insert the square nut into the 

square slit of the cover and start threading the #4 screw into 

the side of the cover. Close the cover and conduct a walk 

test. After testing, take the unit out of walk test mode and 

close the cover again. Finally, finish threading the #4 screw 

until it is snug.

Use the panel’s installation guide to verify proper system setup.

IN

STALL

G

U I D E

I

Mounting Tips

•  Avoid direct sunlight

•  Avoid facing directly to AC or heating vents

•  Avoid vapor or high humidity

•  Avoid curtains, screens, etc. from blocking detection

•  Do 

not 

install outdoors 

 RE659 360 Motion Sensor

 Encrypted

Содержание Connect+ RE659

Страница 1: ...back plate over the screws and rotate the back plate Screw the third 8 screw through the wall tamper into the ceiling ensuring that the wall tamper screw is attached to something solid Tighten all screws until snug Then insert the square nut into the square slit of the cover and start threading the 4 screw into the side of the cover Close the cover and conduct a walk test After testing take the un...

Страница 2: ...cted The LED will light up and an alarm will be sent whenever motion is detected if the unit is in Walk Test Mode In Normal Mode the unit will only send an alarm every 2 minutes and the LED will only light up if the LED ON jumper is connected Detection Range Pulse Count Select 2 for normal applications Select 4 for use in areas where there may be movement by small animals or other objects such as ...

Страница 3: ...es not light up in normal operation LED switch is OFF battery is dead Turn LED switch ON change battery Pro Tips Save battery life by taking unit out of walk test mode after completing walk test There is no 2 minute delay when in walk test mode Leaving in walk test mode will severely decrease battery life Light changes will cause the sensor to trip Ensure that the detector is not placed near windo...

Страница 4: ...wo conditions 1 This device may not cause harmful interference 2 This device must accept any interference that may be received including interference that may cause undesired operation Changes or modifications not expressly approved by Alula could void the user s authority to operate this equipment FCC ID U5X RE359 TRADEMARKS Alula and Connect are trademarks owned by Alula Holdings LLC Specificati...

Отзывы: