Altusen ALTUSEN KN2116, Руководство пользователя

Страница: 67 / 141

Chapter 3. Administration
51
1. Select the desired attributes for the port, then click OK . You return to the
previous screen (Setting I/O Module Attributes). To exit without saving
your changes, click
Cancel .
2. When you return to the previous screen, click Apply to keep your changes.
To exit without saving your changes, click Cancel .
Miscellaneous
The functions performed by the remaining elements at the bottom of the screen
are described in the table, below:
Parameter Explanation
Reset on Exit Placing a check here causes the KN2108 / KN2116 to reset itself
and implement all the new changes when you log out. Following the
reset, wait approximately 30 to 60 seconds before logging back in.
For example, if you change the IP address in the Network dialog
box, you must open this page and enable Reset on exit before
logging out. Otherwise, the change will not take effect
Reset Values Clicking this button undoes all changes that have been made to the
Configuration and Administration pages (except for the Port Names
that were assigned to the Ports - see
Port Names , page 32) and
returns the parameters to the original factory default settings
(see
OSD Factory Default Settings , page 119).
Clear Name List This function clears the Port Name settings.
kn2116.book Page 51 Thursday, July 10, 2008 4:05 PM