KL3116 / KL3116T User Manual
40
F4: ADM
F4 is an administrator only function. It allows the administrator to configure and
control the overall operation of the OSD. To change a setting, double click it; or
use the up and down arrow keys to move the highlight bar to it then press
[Enter]
.
After you select an item, a submenu with further choices appears. Double click
an item, or move the highlight bar to it then press
[Enter]
. An icon appears
before the selected item to indicate which one it is. The settings are explained
in the following table:
(Continues on next page.)
Setting
Function
SET USER
LOGIN
Use this function to set usernames, passwords and fingerprints for
the administrator and users.
Usernames and passwords for one administrator and four users
can be set.
After you select the administrator field or one of the user fields, a
screen that allows you to key in the username and password
appears. Usernames and passwords can be from 1 to 16
characters long and can consist of any combination of letters
and numbers (A–Z, 0–9) and some additional keys (* ( ) + : - , ? .
/ space).
For each individual, key in the username and password, confirm
the password, then press
[Enter]
.
To modify or delete a previous username and/or password, use
the backspace key to erase individual letters or numbers. Press
[Enter]
when done.
Usernames and passwords are not case sensitive. Usernames
are displayed in capital letters in the OSD.
SET
ACCESSIBLE
PORTS
This function allows the administrator to define user access to the
computers on the installation on a port-by-port basis. For each
user, select the target port; then press the
[Spacebar]
to cycle
through the choices:
F
(full access),
V
(view only), or blank. Repeat
until all access rights have been set, then press
[Enter]
. The
default is
F
for all users on all ports.
A blank setting means that no access rights are granted. The
port will not show up on the user's LIST on the main screen.
The administrator always has full access to all ports.
SET LOGOUT
TIMEOUT
If there is no input from the console for the amount of time set with
this function, the user is automatically logged out. A login is
necessary before the console can be used again.
This enables other users to gain access to the computers when the
original user is no longer accessing them, but has forgotten to log
out. To set the timeout value, key in a number from 1–180 minutes,
then press
[Enter]
. The default setting of 0 disables this function.
kl3116-3116t.book Page 40 Wednesday, June 1, 2011 1:28 PM
