AL6003X220
Triple Output Access Control Power Supply/Charger
Overview:
The AL6003X220 triple output access control power supply/charger is specifically designed for use with access control
systems and accessories. The AL6003X220 converts a 220VAC 50/60Hz input into three individually PTC protected
5VDC, 12VDC and 24VDC regulated outputs (see specifications).
Specifications:
Stand-by Specifications
(current is specified on AL3XB input)
:
Output
4 hr. of Stand-by &
5 Minutes of Alarm
24 hr. of Stand-by &
5 Minutes of Alarm
60 hr. of Stand-by &
5 Minutes of Alarm
24VDC / 12AH Battery
--------
Stand-by = 200mA
Alarm = 6.0 amp
--------
24VDC / 40AH Battery
Stand-by = 6.0 amp
Alarm = 6.0 amp
Stand-by = 1.0 amp
Alarm = 6.0 amp
Stand-by = 300mA
Alarm = 6.0 amp
Installation Instructions:
The AL6003X220 should be installed in accordance with article 760 of The National Electrical Code or NFPA 72, as
well as all applicable Local Codes.
1. Mount the AL6003X220 in the desired location.
2. Connect AC power to the two black and two white flying leads of the transformer. Secure green wire lead to
earth ground (Fig. 1). Use 18 AWG or larger for all power connections (Battery, DC output).
3. Measure output voltage before connecting devices. This helps avoiding potential damage.
4. Connect devices to be powered at 5VDC to the terminals marked [+ Out 3 - ].
5. Connect devices to be powered at 12VDC to the terminals marked [+ Out 2 - ].
6. Connect devices to be powered at 24VDC to the terminals marked [+ Out 1 - ].
7. Connect two (2) 12V Stand-by batteries.
Note: For Access Control applications batteries are optional. When batteries are not used, a loss of AC will result in
the loss of output voltage. Batteries must be lead acid or gel type if used. Two (2) 12V Stand-by batteries
connected in series to terminals marked [+ BAT -- ] (Fig. 1, pg. 3).
8. It is required to connect supervisory trouble reporting devices to outputs marked [AC FAIL, LOW BAT] (Fig. 1, pg. 3).
Use 22 AWG to 18 AWG for AC Fail & Low Battery reporting. AC Failure will report in 5 minutes.
Input:
• Input 220VAC (working range 198VAC - 256VAC),
50/60Hz, 1.25 amp.
Output:
• 1.75 amp continuous supply current @ 5VDC.
• 1.75 amp continuous supply current @ 12VDC.
• 3 amp continuous supply current @ 24VDC.
• Filtered and electronically regulated outputs, 100mV
peak output voltage ripple.
Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.
• Maximum charge current 0.7 amp.
Battery Backup
(cont’d)
:
• Zero voltage drop when switched over to
battery backup.
Supervision:
• AC fail supervision (form “C” contacts).
• Low battery supervision (form “C” contacts).
Additional Features:
• Thermal and short circuit protection with auto reset.
• Power supply is complete with enclosure, cam lock, and
battery leads.
Enclosure Dimensions
(H x W x D approximate)
:
15.5” x 12” x 4.5” (393.7mm x 304.8mm x 114.3mm)
