Altman Spectra Cyc 100, Руководство по обслуживанию и запасным частям

Страница: 14 / 45

Spectra Cyc LED Luminaires Service Manual
12
Maintenance Procedure
How to Replace the Power Supply on a Spectra Series CYC Fixture
Note: The following will show you how to take a SSCYC100 apart but the same can be done for the 50, 200 and 400
units.
The following Tools will be needed to complete this task
1 x Phillips Head Screwdriver
DANGER: Before beginning procedure BE SURE AC LINE POWER IS DISCONNECTED.
The following steps will walk you thru how to replace the LED Power Supply on a Spectra CYC.
Get access to the Rear Assembly of the Spectra Cyc.
Follow the steps on page 8 on how to Disassemble a Spectra CYC Fixture. Figure 1
Unplug the 54-5915 P/S to Driver Harness as well as the 54-3075 EMI Filter to P/S Harness.
Figure 2
Unscrew the 4 screws holding the Power Supply to the Rear Assembly.
Figure 3
Once the screws have been removed, the power supply should be free to come out of the unit.
Figure 4
1.
2.
3.
4.
You will follow the same steps in reserve order to install the Power Supply 5.
54-5915 -
LED Driver to P/S
54-3075 -
EMI Filter to P/S Harness
Figure 1
Figure 2
Figure 3 Figure 4