Altman Spectra Cyc 100, Руководство по обслуживанию и запасным частям

Страница: 11 / 45

9
Spectra Cyc LED Luminaires Service Manual
Maintenance Procedure
How to Replace the LED Board on a Spectra Series CYC Fixture
Note: The following will show you how to take a SSCYC100 apart but the same can be done for the 50, 200 and 400
units.
The following Tools will be needed to complete this task
1 x Phillips Head Screwdriver
DANGER: Before beginning procedure BE SURE AC LINE POWER IS DISCONNECTED.
The following steps will walk you thru how to repalce the LED Board on a Spectra Series CYC.
Get access to the Front Assembly of the Spectra Cyc.
Figure 1
Follow the steps on page 8 on how to Disassemble a Spectra CYC Fixture.
Next you will remove the screws that are on the bottom base that hold the led board, reflector and heat sink to the
Front Assembly.
Figure 2
Unscrew the two screws that are holding the lens to reflector. Once the lens has been removed the reflector and
its supports will be free to move as well.
Figure 3
Next you will remove the 61-0470 insulator that lays between the reflector and led board. Figure 4
After the screws are removed you will follow the same steps in reserve order to put the led board back on.
Next you will unscrew the 5 screws holding in the led board to the heat sink. After that the led board will be free to
come off the heat sink.
Figure 5
1.
2.
3.
4.
5.
6.
Figure 1 Figure 2 Figure 3
Figure 4 Figure 5