Alternate Heating WOOD GUN Super E210, Инструкция по установке и эксплуатации

Страница: 43 / 73

On Wood Gun™ mod ls quipp d with oil or gas
backup, th control s ttaings should b as follows:
✔
High limit = 200° F
✔ Op rating Limit = 185° F
✔
Switchov r Limit = 145° F
In this way, th oil burn r will function as a
backup and only fier wh n th boil r t mp ratur
drops b low about 145º F. The oil burn r may b s t
v n low r if d sir d to pr v nt it from fiering xc pt
wh n th wood fier is almost compl t ly out.
WARNING: if the operation procedures and wood
requirements are not followed it may result in: poor
combustion, low btu output, creosote in chimney,
debris buildup in heat exhanger, and very poor
efficiency.
*FOR CARBON STEEL BOILERS
Condensation – Causes and Prevention
Exc ll nt combustion will maximiz th amount
of th main byproducts of combustion, carbon
dioxid and wat r. K p in mind that a gr at d al
mor wat r will b produc d by good combustion
than what was originally contain d in your w ll
s ason d wood. The s two sourc s of wat r, add d
tog th r, must b r mov d from th syst m in th
vapor stat to avoid cond nsation. If th xhaust
gas s cool to th cond nsation point, you will s
liquid wat r in your chimn y and/or cyclon , and
possibly v n insid th boil r's h at xchang r.
S v r cond nsation can r sult in so much liquid
wat r that it is misint rpr t d as a boil r l ak. Wh n
wat r is found in th cyclon and/or h at xchang r,
attaack th issu as on r lat d to cond nsation.
Reduce or Prevent Condensation
Cond nsation has s v ral caus s, but can always
b attaack d syst matically and gr atly r duc d or
liminat d. Prop rly utiliz d th rmal storag will
assur st ady load wh n fiering, and assist in k ping
cond nsation und r control. K p in mind that
b caus th Wood Gun swirl tub h at xchang r
xtracts so much h at from th xhaust, th gas s
l aving th syst m ar ofte n not far abov
t mp ratur s that can l ad to cond nsation.
Anything that compromis s p rformanc or cools
stack gas s furth r than normal can trigg r
cond nsation. R vi w th list b low and mak
chang s that match your circumstanc s. B sur to
r vi w th installation s ction of this manual that
cov rs r turn wat r t mp ratur .
✔
Incr as r turn wat r t mp ratur s (mixing
valv , rais op rating t mp ratur )
✔ Ch ck for and corr ct any issu s r lat d to
l aking door s als or Air Valv l aks
✔
Insulat stov pip and/or chimn y to
pr s rv h at
✔
Insulat cyclon
✔
Incr as load
✔
N v r allow mid-burn off cycl s to occur
✔
Us dri r fu l
✔
Cl an boil r, or tak oth r m asur s to
improv air flaow
✔ If you ar obs rving back-pufficng, tak car of
this issu promptly, as p rformanc is
compromis d in a back-pufficng boil r,
possibly contributing to cond nsation
✔
K p r fractory r lativ ly cl ar of charcoal
and ash
✔
Watch loading t chniqu and oth r fier box
manag m nt asp cts, making sur that th
fier burns prop rly upsid down
- 37 -
Note: Condensation in the heat exchanger can be
caused by wood that is too wet for the application
and/or by low return water temperatures.
Recommended return water temperature is
operating temperature minus 20º F. Use a mixing
valve for boiler return water temperature
protection.