Alternate Heating WOOD GUN Super E210, Инструкция по установке и эксплуатации

Страница: 41 / 73

touchscr n will pow r up and will display th
“Hom ” scr n.
If you ar starting a wood fier . Simply pr ss th
“Wood” buttaon. The boil r will start-up and you may
b gin starting a fier .
Starting a fier in th Wood Gun TM is similar to
starting a fier in any wood fier d boil r with a f w
important diff r nc s. B caus th Wood Gun
incorporat s a downward drafte, succ ssful fier
starting r quir s r cognizing that fact and lay ring
kindling accordingly. Plac kindling wood on th
r fractory in a l ngthwis ori ntation. Add a lay r of
crumpl d up n wspap r follow d by anoth r small
lay r of kindling. Light th pap r. Turn on th boil r
switch. Wh n th kindling is burning w ll, add mor
(and larg r) pi c s of wood.
Wh n fiering a cold boil r, it is important to
conc ntrat h at n xt to th r fractory. The Wood
Gun
TM d p nds on high r fractory t mp ratur s for
driving th gasifiecation proc ss. Using dri r, small r
wood will h lp to accomplish this. Add larg r pi c s
only afte r th fier is w ll stablish d. Only fiell th
fu l storag ar a (fier box) afte r th r fractory has
r ach d good gasifiecation t mp ratur indicat d by
an xhaust t mp abov 285F. K p in mind that a
small int ns fier is pr f rabl to a larg smold ring
on to r duc th amount of cr osot d position.
Theis will b accomplish d by building th initial fier
with wood no high r than th door fram . Wh n th
starting charg is burning hot, add th r st of th
charg in sufficci nt quantity to last for up to t n
hours. Long r cycl s ar possibl , but you will want
to plan for utilizing short r burn cycl s p riodically
to provid for good fier box manag m nt. B st
practic s includ k ping ash and charcoal build-up
to a minimum. Wh n d mand is
mod rat
to low,
simply load charg s of fu l that ar just ad quat for
th l ngth of th anticipat d burn cycl . Do not
ov rfiell fu l storag ar a (fier box).
Charging the Boiler with Wood
Wh n it is tim to r load th Wood Gun TM , mak
c rtain th gr n “PURGE” light is on. If th
“PURGE” light is off , push th “PURGE” buttaon and
wait for th light to turn on. Op n th load door
slowly by cracking it op n just a bit to allow air to
flaow in small r quantiti s through th op ning. Afte r
5-10 s conds, you may op n th door fully. Theis
waiting p riod will allow sufficci nt tim for th fier
to b com r -activat d and burn off any gas s that
may hav accumulat d in th fu l chamb r during
th off cycl . Ev n if th gr n light is on,
open the
door cautiously, sinc abruptly introducing air ov r
th glowing fu l particl s may caus it to
t mporarily flaam up.
Wh n r loading th Wood Gun™, it is a good id a
to us th ash rak to mak sur that all of th c nt r
slots ar op n and fr from ash and charcoal b for
adding mor wood. Such raking is r quir d mor
ofte n wh n using softewood, or any wood with a high
ash cont nt. Wood bark has a v ry high ash cont nt
r lativ to th c nt rs of wood pi c s. Wh n using
hardwood, cl ar th slots at l ast daily. Cl ar th
slots by raking charcoal pi c s away from th slots.
Afte r raking th charcoal pi c s away from th slots,
rak ash into th slots, thus aiding th proc ss of
allowing th induction fan to pull th ash through.
- 35 -
Note: Always place wood in the Wood Gun TM
lengthwise (from front to back). Never place wood
in the fuel storage area crosswise.
Observe the warning label on the
load door which cautions that it
must not be opened unless the
green indicator light is on.