D000161-00 Rev. C
14
Enter from the back and step into the opening in the enclosure. It is fine to step on the enclosure
as you enter, but make sure that you have no rocks or sharp objects embedded in the soles of
your shoes that could mar or damage the enclosure.
Installing the Oval Support Frame
Once you are standing on the treadmill in the opening, face
forward and grab the oval-shaped support frame (Figure 2).
Grab the frame on either side of you and lift it up around your
body until it is at waist level and horizontal. Use the numbers
on the height adjusters as a reference and to ensure
alignment between front, back and sides of the support
frame. It is particularly important that the support frame be
level side to side.
Set the support frame at a height that places the zipper at
your iliac crest (the top, outer edge of your pelvic bone felt
just below waist level on either side of your body.). For
additional trunk support the frame can be set higher. See
Figure 3.
With the frame at the correct height, push it into the slots of
the height adjusters in the front and rear (Figure 4) of the
machine. Make sure it is at the same height on both right and
left sides. Push the frame forward until it is fully engaged in
the adjustment slots and contacts the ends of the slots. The rear of the frame can be placed up
to two slots higher or lower than the front.
Verify that the rear pins of the oval support
frame are all the way forward in the slots of
the height adjusters and that the frame is
level from right to left sides. The support
frame should be left in this position for the
remainder of your Anti-Gravity Treadmill
session.
Figure 2
Figure 3
Figure 4
Figure 5
