Altelix LLC USA: 866-660-WIFI (9434) +1 561-660-9434
Copyright (C) 2017 Altelix LLC. All rights reserved. Altelix and the Altelix logo are Trademarks and/or Registered Trademarks of Altelix LLC.
Specifications are subject to change without notice. See
IS0141-B
WARNING: READ ALL INSTRUCTION BEFORE USE. THIS ENCLOSURE IS DESIGNED TO BE
INSTALLED BY A TRAINED PROFESSIONAL INSTALLER.
NFC322412 Series RV4U NEMA Enclosure Instruction Sheet
1. Install M6 Cage Nuts into the square openings to provide an attachment point for the M6 Mounting
Screws.
a
–
From inside of the Mounting Rails, insert one of the flanges of the cage nut through the square opening.
Press against the side of the square opening.
b
–
Compress the cage nut at the sides slightly to allow the remaining flange to fit through the square
opening. When the cage nut is properly installed, both flanges will protrude through the square opening and
will be visible on the outer surface of the mounting rail. Repeat steps 1a and 1b until all required cage nuts
are installed.
2. After installing the required cage nuts, use the included M6 Mounting Screws and M6 Washers to secure
your equipment.
NOTE: The rack can hold up to 44 pounds evenly distributed.
The provided mounting feet can be used to mount the
enclosure to most surfaces or you can use the appropriate
Altelix pole or wall mount kit sold separately on our website.
To install the mounting feet, first drill through the 4 recessed
holes in the back of the enclosure. Be sure to follow proper
safety procedures when drilling. Once drilled, use the provided
M6 nuts and bolts to fasten the mounting feet to the back of
the enclosure.
Mounting Feet
Equipment Mounting
