Altec ATP-23, Руководство пользователя

Страница: 23 / 29

23
Dump mode
Printer will enter dump mode after printing printer configuration. In the dump mode, all characters will be
printed in 2 columns as following. The left side characters are received from your system and right side
data are the corresponding hexadecimal value of the characters. It allows users or engineers to verify and
debug the program.
Note:
1.
Dump mode requires 2” wide paper width.
2. Turn off / on the power to resume printer for normal printing.
3. Press FEED button to back to the previous menu.
4.3.3 Printer Initialization
Printer initialization is used to clear DRAM and restore printer settings to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during the 5 blinks).

The LED color will be changed as following:
Amber

red (5 blinks)

amber (5 blinks)

green (5 blinks)

green/amber (5 blinks)

red/amber (5 blinks)

solid green
Printer configuration will be restore to defaults as below after initialization.
Parameter Default setting
Speed
127 mm/sec (5 ips) (203DPI)
76.2 mm/sec (3 ips) (300DPI)
Density 8
Label Width
2” (50.8 mm)
Label Height
2” (50.8 mm)