1. Ma
2. For a look at the various buttons on your speaker, view the graphic below.
ke sure the following items are
included in your package.
USB Cable
AC Adapter
LifeJacket XL
Bluetooth Speaker
Mount
AUX Cable
Item # IMW789
Quick Start Guide
3. Connect one end of the included USB Cable into the Micro USB charging port on
your speaker. Plug the other end of the USB Cable into the included AC Adapter.
Then plug the AC Adapter into a suitable power outlet in your home in order to charge
your speaker’s internal battery. A full charge takes approximately 4 hours.
Charging:
When charging, an orange LED light will illuminate. The orange light will
turn off when your speaker is fully charged.
-Pairing Your Speaker with a Bluetooth Phone
Power On
Play / Pause........................................Press
Volume Up / Down..............................Press + or -
Disconnect Device....Hold + and -
Answer / End Call............................... Press
Stereo Plus Pairing............................Hold for 2 Seconds
Next Track..........................................Hold +
Previous Track....................................Hold -
Power O ............................................Hold for 2 Seconds
Pairing Mode /
............................................Hold for 2 Second
4. Pairing Your Speaker with a Bluetooth Device
-Powering on your LifeJacket XL Speaker and Entering Pairing Mode
-Using Near Field Communication to Pair Your Speaker with a Bluetooth Audio Source
When you power on your LifeJacket XL speaker for the
With Near Field Communiation (NFC), you can easily
pair and connect your speaker to a compatible
audio source. Once your speaker is powered on and in pairing
mode, just hold your NFC enabled device directly against the
wireless check in spot on your speaker.
Once your speaker is powered on and in pairing mode,
go to the Bluetooth settings menu, make sure that
Bluetooth is turned on, and then select
“LifeJacket XL” to pair.
Note: Pairing mode times out in approximately three minutes.
first time, it will automatically go into pairing mode. The LED
status light will flash rapidly as your speaker searches
for a Bluetooth audio source to pair with.
Once you have successfully paired your speaker with a Bluetooth audio source, the LED status light will stop
flashing rapidly, and begin shining steadily while remaining blue. In addition, your speaker will emit an audible
tone to confirm that pairing was successful.
-Pairing Additional Bluetooth Devices to the LifeJacket XL Speaker
By holding down the and Volume - buttons simultaneously, your speaker will again go
into pairing mode. The LED status light will flash rapidly, as your speaker searches for another Bluetooth
audio source to pair with.
5.By downloading the “ALTEC CONNECT” app (for iOS and Android)
6.You can also use the included 3.5mm Auxiliary Cable to
connect audio devices through the AUX In port on your speaker
you can personalize your LifeJacket XL speaker.
ALTEC CONNECT will allow you to:
-Enable the
Stereo Plus Pairing
setting
-Control Play/Pause/Skip/Volume/Mute
-Get over the air software updates
-Select EQ sound settings
Indicator Light
LIFEJACKET XL
RUGGED BLUETOOTH SPEAKER
Using the Mount:
The included mounting bracket allows you to attach your
speaker to cylinder shaped surfaces such as the handle bars of a bicycle or ATV, or
the rails on a yacht. This bracket comes unassembled. To use it, first attach the
pieces as shown below. Next connect your speaker by screwing it into your
speaker’s tripod mount, and then attach the bracket to a suitable surface. Use the
included wrench to help you loosen or tighten when necessary.
