Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
needed, IP address of the NTP server must be added and C1n Series AP/CPE will
synchronize with the NTP server. It is useful to maintain the network and make sure all
APs are using the same system time by setting the same NTP server.
IP
Address
Type
: IPv4 or IPv6. (Please note that IPv6 is available only if enabling IPv6 in
Network setting web page).
NTP
Server
IP
: NTP server IP address, please click “
” to add new NTP server IP
address.
NTP
Polling
Interval
: By default, it is 600s
NTP
Time
Zone
: Time Zone setting, by default it is Asia/Hong Kong.
Daylight
Saving
Time
: By default, it is not selected.
“Historical Statistics Collection Setting” is used to set Historical Statistics function and
the sampling frequency.
Enable Historical Statistics
: Enable or Disable Historical Statistic function.
Sampling Frequency
: Specify sampling frequency of statistics ; the default setting is 30
seconds per sample.
Procedures:
Select
Configuration
->
System
，
to go to system setting page.
1.
Type in the system information if necessary.
2.
Assign NTP IP address in
NTP
Server
IP
.
Click “
” to add NTP server if necessary.
3.
Set polling interval in
NTP Polling Interval
from 15s to 86400s. The default setting is
4.
600s.
Choose suitable time zone in
NTP Time
Zone
5.
Enable day light saving time in
Daylight Saving Time
if necessary
6.
Enable Historical Statistics function and select sampling frequency if necessary
7.
Click
Submit
8.
Click
Save&Apply
to commit changes.
9.
5.3.
Network Configuration
User may configure the network via
Configuration
->
Network
. The configuration
includes General Network Setting, VLAN, DHCP, Port Forward, and Safe Mode.
5.3.1.
General Network Configuration
User may configure the network via
Configuration
Network
General
. The
parameters include Network Setting, WAN Setting (IPv4 and IPv6), STP Setting,
WLAN/LAN Interface Assignment, LAN Setting, and Ethernet Setting.
