IMPORTANT SAFETY INSTRUCTIONS
20529-001
LED DUAL MOUNT
SWING ARM WALL SCONCE
For Customer Assistance:
www.evolutionlightingllc.com
Made In China
Read and Save:
1. To reduce the chance of fire or electrical shock: Do not install non-factory wiring or any other electrical components.
Altering or modifying the lamp in any way will render the lamp unsafe.
2. Keep curtains, shades, wall hangings and all other fabrics and objects away from the lamp canopy, lamp shade and light
bulb. Unit is not designed to support additional weight. Do not hang objects from the lamp or any lamp part.
3. Before starting the installation, disconnect the power by turning off the circuit breaker or removing the appropriate fuse
at the fuse box. Turning off the power at the light switch is
not
sufficient to prevent electrical shock.
4. This unit is suitable for installation in a dry, indoor location only.
5.
Electrical Connections:
All electrical connections must be in accordance with local codes, ordinances and the National
Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified,
licensed, electrician.
6.
Tools and Materials Required:
(Not Included) Flathead screwdriver, wire cutters, ladder, pliers,
U.L./CSA listed electrical tape.
7. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment on and off, the user isencouraged to try to correct the interference
by one or more of the following:
- Reorient or relocate the receiving antenna.
- Increase the separation between the lighting unit and receiver.
- Connect the lighting unit into an outlet on a circuit other than the outlet which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for assistance.
NOTE: Please note that changes and modifcations not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
LIGHT BULB REPLACEMENT
Integrated LED bulb replacement not required.
CLEANING AND MAINTENANCE
1. Clean using a mild cleaning solution and a soft cloth.
2. Never use a rough cloth or chemical cleaners containing acids, abrasives or solvents.
