Alstom Reason RPV311, Техническое руководство

Страница: 95 / 350

RPV311 Chapter 4
– Configuration
RPV311-TM-EN-6 95
C The T
RIGGER LOGIC
field contains all the thresholds created. The logic equation uses AND and OR logic
operators over previously defined thresholds. Initially, all preset thresholds are displayed as implicit OR
operators, one per line.
To enable thresholds individually, click on the threshold and select E
NABLE
;
To disable discarded thresholds individually, click on the threshold and select D
ISABLE
;
To break or remove complex thresholds, click on the threshold and select C
UT LAST
;
To create equations with AND operators, follow the procedures below:
o
Click on the threshold and select Cut last;
o
Click on the threshold to which is desired to add the previously selected threshold and then
select the threshold to be added.
D Selecting the R
ECEIVE
E
THERNET CROSS
-
TRIGGER
or S
END
E
THERNET CROSS
-
TRIGGER
check box enables
these features. It allows the start of the recording of an exceeded threshold by Ethernet cross-trigger.
E The R
ATE
scroll box allows user to select the rate on the fault recorder (64, 128, or 256).
10.2 CONTINUOUS RECORDING
In this section, shown in the figure below, is possible to configure the equipment's continuous recorder.
Figure 32: Fault recorder
– continuous recording configuration section