User Guide Information Version1.0
May 19, 2006
4. Eligibility requirements for regulatory approval:
As a part of regulatory certification, ALPS will provide an approval for certain countries in the form of
modular approval (MA) .
The regulatory approval is required for each country throughout world where the end-user wishes to use
ALPS UGPZ8 into entire end product, if no certification program for the modular approval exists in the country.
The countries that can accept MA include the USA, Canada, certain European countries and others.
The conditions for approval of ALPS UGPZ8 and related information for each country are described below.
ALPS wishes that our customer for end product would contact with us about what module of UGPZ8 has
been certified for each country.
5.1 USA
5.1.1 Compliance statement to FCC
This module complies with part 15 of the FCC rules. Operation is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
5.1.2
RF exposure compliance
This module may be installed into any end product in mobile device applications.
For Mobile Configuration, this module complies with FCC radiation exposure limits set forth for
uncontrolled equipment and meets the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65.
This module has very low levels of RF energy that it deemed to comply without maximum permissive
exposure evaluation (MPE).
But it is desirable that it should be installed and operated with at least 20cm and more between the
radiator and person’s body (excluding extremities: hands, wrists, feet and legs).
5.1.3 Requirements to end product
The following provisions for end product will be required on the FCC regulation, part 15.
(1) Antenna
The UGPZ8 module provides own internal metal antenna.
ALPS wishes that our customer shall use the module without any modifications including antenna.
If customer use a unique antenna, the FCC certification is required for the end product.
(2) Co-location.
This UGPZ8 module must not be co-located or operated in conjunction with any other antenna or
transmitter.
(3) Markings
To satisfy FCC exterior labeling requirements, the following text must be placed on the exterior of the
end product.
Contains Transmitter Module FCC ID: CWTUGPZ8
Any similar wording that expresses the same meaning may be used.
(4) Caution to user for modification
The following caution is expressed on the user’s instruction manual of the end product.
The changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
device.
Copyright
©
2005 ALPS ELECTRIC CO., LTD.
page3
