14
-EN
Accessory List
•
INE-W990BT ........................................................................1
•
Power cable.........................................................................1
•
Flush head screw (M5×8)....................................................6
•
Screw (M5×8) ......................................................................8
•
GPS Antenna ......................................................................1
•
Antenna mounting plate ......................................................1
•
CAMERA/AUX/PRE OUT cable ...........................................1
•
USB extension cable ...........................................................1
•
Microphone..........................................................................1
•
Mounting sleeve ..................................................................1
•
Face plate............................................................................1
•
Bracket key..........................................................................2
•
Rubber cap..........................................................................1
•
Hex bolt ...............................................................................1
•
Owner’s Manual ..............................................................1set
Location of Controls
c
(Eject) button
Ejects a disc.
/
(UP/DOWN) button
Press to adjust the volume.
MUTE/
C
button
Press to activate /deactivate the mute mode.
Press and hold for at least 3 seconds to turn the power off.
(Phone)/VOICE CTRL. button
Recalls the Telephone Menu screen.
When a voice dial compatible hands-free phone is
connected, press and hold for at least 3 seconds to switch
to the Voice Dial screen.
/
button
This action varies according to the Audio/Visual source.
(Track Up/Down, Fast reverse/Fast forward, etc.)
/
button
Each time you press this button, the Navigation mode and
the Audio/Visual Source mode are changed alternately.
Press and hold for at least 3 seconds to activate the Quick
Sound screen.
For details of navigation operations, refer to “Navigation
System OM” in the CD-ROM.
DISC Slot
RESET switch
The system of this unit is reset.
Remote Sensor
Point the remote control transmitter towards the remote
sensor within a range of 2 metres.
Turning Power On or Off
Some of this unit’s functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Turn the ignition key to the ACC or ON position.
The system turns on.
•
When turned on, the system displays the last mode screen that
was displayed before the ignition key was turned off. For
example, if the unit is in radio mode when ignition is turned off,
it will remain in radio mode when ignition is turned back on.
2
Press and hold the
MUTE button
for at least 3
seconds to turn the power off.
•
The unit can be turned on by pressing any button.
•
The INE-W990BT is a precision device. Careful handling of the unit
should provide you with years of trouble-free operation.
Getting Started
Optional Remote Control Interface Box
This unit is operable using the vehicle’s secondary radio controls.
An Alpine Remote Control Interface Box (optional) is required. For
details, contact your Alpine dealer.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control.
For details, consult your Alpine dealer. Point the optional remote
control transmitter at the remote control sensor.
About the button descriptions used in this Owner’s
Manual
The buttons found on the face of the unit are expressed in
bold (e.g.
MUTE
). The buttons found on the touch-screen
display are shown in bold within brackets, [ ] (e.g.
[
]
).
Содержание INE-W990BT
Страница 97: ......
