Alpine INA-N333RRS, Руководство по обслуживанию

Страница: 51 / 88

INA-N333RS/INA-N333RRS
No. Symbol I/O Terminal Description
94 N-St I Audio u-COM communication start signal input terminal.
95 IS-BUS-FIN I Internal serial BUS frame signal input detection terminal.
96 REMOCON I Remote control signal input terminal.
97 D-Rx I Audio u-COM data input terminal.
98 D-Tx O Audio u-COM data output terminal.
99 A-CLK O Audio u-COM CLK output terminal.
100 RDS-RX I RDS monitor data input terminal.
M30803FGGP :
IC901
No. Symbol I/O Terminal Description
1 K06 O Key matrix scan signal output terminal.
2 ENCO-1 I Rotary encoder inner axis-A input terminal.
3 ENCO-2 I Rotary encoder inner axis-B input terminal.
4 ENCO-3 I Rotary encoder outside axis-A input terminal.
5 ENCO-4 I Rotary encoder outside axis-B input terminal.
6 BYTE I External data BUS width switching input terminal. (connect VSS) (16 Bit width)
7 CNVSS - Processor switching input terminal. (connect VSS) (extension Mode)
8 RED
9 GREEN
10 RESET I System RESET input terminal.
11 XOUT O Crystal connect terminal for main system clock OSC. (20MHz)
12 VSS - GND potential supply terminal.
13 XIN I Crystal connect terminal for main system clock OSC. (20MHz)
14 VCC - +5V power supply supply terminal.
15 PUSH-SW I Rotary encoder PUSH-SW input terminal.
16 NAVI-CS I NAVI u-COM communication start signal input terminal.
17 FIN I IS-BUS FIN input terminal.
18 YD I OELD communication ERROR watch-dog signal input terminal.
19 RY/BY I External ROM RY/BY signal input terminal.
20 EXCLK O EXCLK output terminal for OELD driver IC (M66710FP).
21 K05
22 K04
23 K03
24 K02
25 K01
26 DIMMER O OELD Unit DIMMER signal output terminal.
27 AUDIO-RX I IS-BUS Rx input terminal.
28 AUDIO-TX O IS-BUS Tx output terminal.
29 F-TX O Flash writing Tx output terminal.
30 F-RX I Flash writing Rx input terminal.
31 SCLK I Flash writing SCLK input terminal.
32 BUSY O Flash writing BUSY output terminal.
33 FOUT O IS-BUS FOUT output terminal.
34 NAVI-DATA O NAVI u-COM communication data signal output terminal.
35 NAVI-CLK O NAVI u-COM communication clock signal output terminal.
36 CON-RESET O RESET output terminal for OELD driver IC (M66710FP).
37 RDY I External ROM RDY input terminal.
O Lighting switching signal output terminal.
O Key matrix scan signal output terminal.
- 51 -
TO CONTENTS
TO SCHEMATIC