The first 8 inactivated zones are now showed. The display will automatically go on with the next 8
inactivated zones, until all inactivated zones are shown. Pressing the <
↓
> key again will show the inactivated
zones separately again.
It is possible to set more keypads to the walktest mode, which is useful with large installations, in which
several keypads are used. Do not forget to close off the walktest mode at the keypad when finished, since the
walktest mode is only closed off completely when this is done on all keypads!
To exit the walktest mode on a keypad, press the <*> key.
F21# Display open zones
Function 21 can be used to get an overview of all zones that are open at the moment. This overview works
identical to the way the walktest works. Also open delayed zones are shown. These zones are allowed to be
open when the system is armed.
Press <?> <2> <1> <#>, followed by a level 2 or higher code. The following message will appear on the
display:
Following zones
are open:
When none of the zones are open, the following message will appear within a few seconds:
No open zones in
section(s)
When there are zones open, these will be shown automatically in numerical order. For example:
Zone 03 is open :
Livingroom
By pressing the <#> key the next zone is shown more rapidly. This allows you to scroll fast through the open
zones. By pressing the <
↑
> key the display will return to the first open zone. When open zones are closed,
these will disappear from the list.
You can also get a short overview of the open zones by pressing the <
↓
> key. The display will turn to:
03. 05. 06.
08. 09. 13. 15.
The first 8 open zones are now shown. The display will automatically continue and show the next 8 open
zones, until all open zones are shown. You can go back to view by zone by pressing the <
↓
> key once again.
When all zones are shown, the following message will appear on the display:
End displaying
open zones. <#>
Pressing the <#> key will exit the show open zones function.
Note: when activating this function using a code which is valid for section A only, only the open zones
belonging to section A can be viewed.
F22# Display available information
Function 22 is used to show actual information the control panel wants to inform the user about. For more
information, see chapter “Controlling the AlphaVision NG control panel”.
AlphaVision NG installation manual Rev. 2.0 27-08-2003 Blz. 76/101
