Alpha C016-1001-10, Инструкция по установке и эксплуатации

Страница: 6 / 22

6
C048-699-30 R03, Rev. B (01/2021)
2.3 2.3 Monitoring Options Monitoring Options
The DCX battery disconnect system includes monitoring features
for local and remote status indication:
LED indicators “ON-LINE”, “OFF-LINE”, “ALARM/FAULT”, “EPO
TRIPPED” (see Figure 1). Alarm contacts: Form-C relay contacts
to provide breaker trip status.
y
ON-LINE: The battery string is connected – circuit
breaker/switch is ON.
y
OFF-LINE: The battery string is disconnected – circuit
breaker/switch is OFF.
y
ALARM/FAULT or OPTION STATUS – provides
information for any installed option, such as the TRD
VRLA Battery Thermal Runaway Detection System
NO LIGHT: No option is installed
GREEN LIGHT: Option is installed and working normally
RED LIGHT: Option is in alarm (for more information,
refer to the installed option's manual)
y
EPO TRIPPED – Emergency Power Off input is active.
This indicator is not persistent.
Figure 1. LED Indicators
3.0 3.0 Unpacking and Inspection Unpacking and Inspection
The DCX battery disconnect system is shipped in a box that includes protective inserts for the main DCX housing as well
as the mounting bracket component set and related hardware.
Inspect the outer box immediately after receipt as well as the contents to confirm that there is no shipping damage. Most
shipping carriers require notification within 24 hours of delivery of any shipping damage in order to cover the cost of the
damage via repair or replacement. It is the responsibility of the recipient to inspect the shipment immediately upon receipt.
Remove the DCX unit and related brackets and hardware and confirm that the components are present. Refer to the
mounting kit instruction sheet that comes with the shipment and is specific to the mounting kit option that was ordered to
confirm that all parts are present for installation.
The plastic flip-up front panel and the plastic housing of the DCX unit are not designed as structural components so be
careful to lay the unit on it’s side or back temporarily until it is mounted to the mounting bracket set to avoid damage.
Arrange the mounting bracket kit including hardware for preparation for installation at the install location.
3.1 3.1 Package Contents Package Contents
y
DCX
™
Series top terminal battery disconnect unit (Figure 2, A.)
y
Battery mounting kit with hardware (ordered separately)
y
Mounting bracket(s) (Figure 2, B.)
y
Copper battery termination bus (Figure 2, C)
4.0 4.0 Installation Installation
4.1 4.1 Installation Kit Options Installation Kit Options
Refer to Section 6 on Page 15 for ordering information.
Battery top terminal mount installation kits for the DCX battery
disconnect system are available for the following battery manufacturers:
y
EnerSys
®
y
C&D Technologies
®
y
GNB
®
y
East Penn Manufacturing
Figure 2. Package Contents
A.
B.
C.