Installation
5.1 Installation on the surface
1. Detach the device from the mounting base using a suitable screwdriver.
2. Mark two diagonally opposite drill holes using the mounting base.
3. Install the mounting base with the correct screws.
4. Position the device onto the mounting base and latch it into the clips.
5.2 Installation onto flush-type box
The fixing holes in the mounting base can be used for installation onto a flush-type box.
1. Detach the device from the mounting base using a suitable screwdriver.
2. Install the mounting base with the correct screws.
3. Position the device onto the mounting base and latch it into the clips.
5.3 Installation with adhesive strips
Depending on the surface, installation can be performed with double-sided adhesive tape. Installation is possible on differ-
ent surfaces as e. g. masonry, furniture, tiles, or glass.
In case of installation with adhesive strips the installation surface must be even, smooth, undamaged, clean, and free from
grease and solvents.
1. Select a suitable installation position.
2. Remove the protective foil from one side of the adhesive strip.
18
Содержание RDS 61011-N Series
