Alpha Outback Energy Tri Power X33 HE, Руководство пользователя

Страница: 30 / 53

Page 29 to 52
Mains start-up
Close the SWIN and SWBYP (if present) and leave the SWMB maintenance isolator open.
After a few moments the TRI POWER X33 HE will be activated. The condensers are pre-charged and the
"Lock / stand-by" led will start to flash: The TRI POWER X33 HE is in stand-by mode.
Press the button to access the start-up menu. When requested to confirm, press “YES” and then press
the button again to confirm. All LEDs on display will turn on for about a second and you should hear a
beep. The start-
up sequence ends when the TRI POWER X33 HE enters the “load on inverter” status.
Battery start-up
Keep the “Cold Start” button (located behind the door) pressed for about 5 seconds. The TRI POWER X33
HE will be activated and the display will turn on.
Press the button to access the start-up menu. When requested to confirm, press “YES” and then press
the button again to confirm. All LEDs on display will turn on for about a second, and the buzzer will beep
once every 7 seconds. The start-
up sequence ends when the TRI POWER X33 HE enters “battery working”
mode.
Note: if the sequence described above is not carried out within 1 minute, the TRI POWER X33 HE will turn off
automatically so not to discharge the batteries unnecessarily.
Switching off the TRI POWER X33 HE
From the main menu, select the “SWITCH OFF” button and press to enter the submenu. Press the button again
to confirm
the operation. The TRI POWER X33 HE will enter “stand-by” mode. To switch off the TRI POWER X33
HE completely, open the SWIN and SWBYP (if present) input isolators.
Note : During long idle periods, it is recommended to switch off the TRI POWER X33 HE and then, while
the display is off, open the battery fuse holders.