Alpha Outback Energy Tri Power X33 HE, Руководство пользователя

Страница: 11 / 53

Page 10 to 52
INSTALLATION
ALL OPERATIONS DESCRIBED IN THIS SECTION MUST BE CARRIED OUT BY QUALIFIED
PERSONNEL ONLY.
The company assumes no responsibility for any damage caused by flawed connections or by
operations that are not described in this manual.
Storage of the Tri Power X33 HE
The storage area must respect the following characteristics:
Temperature: 0°÷40°C (32°÷104°F) Relative humidity degree: 95% max
Preparation for installation
Preliminary information
TRI POWER X33 HE Models 30 40
Nominal power
30kVA 40kVA
Operating temperature 0 ÷ 40 °C
Max. relative humidity during operation 90 % (no condensation)
Max. installation height
1000 m at nominal power rating
(-1% power for every 100 m over 1000 m)
max 4000 m
Dimensions W x D x H 440 x 850 X 1320 mm
Weight with no batteries 135kg 145kg
Weight with batteries
335kg 345kg
Dissipated power with nominal resistive
load (pf=0.9) and buffer battery (1)
1.4 kW
1205 kcal/h
4780 B.T.U./h
1.5 kW
1290 kcal/h
5120 B.T.U./h
Dissipated power with nominal distorting
load (pf=0.7) and charged battery (1)
1.34 kW
1150 kcal/h
4565 B.T.U./h
1.35 kW
1160 kcal/h
4605 B.T.U./h
Flow rate of the fans to remove heat from
the installation area (2)
750mc/h 800 mc/h
Current dispersion to earth (3)
< 50 mA
Protection level IP20
Cable input On the rear from the bottom
(1)
3,97 B.T.U./h = 1 kcal/h
(2)
The following formula can be used to calculate the air flow rate: Q [mc/h] = 3,1 x Pdiss [kcal/h] / (ta - te) [°C]
Pdiss is the power expressed in kcal/h dissipated by all the devices installed in the installation environment.
ta= ambient temperature, te=external temperature. In order to take leaks into account, it is necessary to
increase the value obtained by 10%.
The table shows an example of a flow rate with (ta - te) =5°C and a rated resistive load (pf=0.9).
(Note: This formula is applicable only if ta>te. If not, the TRI POWER X33 HE installation requires an air-
conditioning system).
(3)
The dispersion current of the load is added to that of the TRI POWER X33 HE on earth wire.