DEU
ENG
21
Commissioning
Alpha IP SMO 63001
5 Commissioning
5.1 Teach-in of the device
Prior to operating the SMO 63001, it must be integrated into the Alpha
IP system via the Access Point (HAP 21001). For this, teach-in the respec-
tive device as follows.
Ö
The Alpha IP Access Point has been set up via the Alpha IP app.
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
3. Remove the motion sensor from the wall-mount support (see figure
on the left).
4. Rotate the battery compartment cover (see „Device overview“ page
20) and remove it.
5. Remove the insulating strip from the battery compartment.
9
No movement detection for approximately 30 seconds.
9
The teach-in mode is automatically activated for three minutes.
The teach-in mode can be activated manually for 3 minutes via the
system key (see „Device overview“ page 20).
6. The device will be displayed automatically in the app.
7. For confirmation of the teach-in process, enter the last four digits of
the device number (SGTIN) in the app or scan the supplied QR code.
The device number can be found on the back side of the device.
The LED will light up in green after a successful teach-in process. The
process must be repeated if the LED lights up in red.
9
The function test starts.
The function test starts for a duration of 10 minutes after a successful
teach-in process. When the PIR lens detects a movement, the device
LED lights up. This allows a direct test of detection range and sensitiv-
ity. When the time has elapsed, the device changes to the individually
set configuration.
8. Put on and rotate the battery compartment cover until it clicks into
place.
9. Follow the directions of the Alpha IP app.
1
2
