DEU
ENG
FRA NDL ITA ESP DAN/NOR
FIN
SWE POL RUS
23
Commissioning
Alpha IP WTH 61001
5 Commissioning
5.1 Teach-in of the device
Prior to operating the device, it must be integrated into the Alpha IP
system via the Access Point (HAP 21001). Teach-in the device as follows:
Ö
The Alpha IP Access Point has been set-up via the Alpha IP app (see
manual HAP 21001).
1. Open the Alpha IP app on your smart phone.
2. Select the menu item Teach-in device.
3. Pull the room control unit Display S from the interchangeable frame
(see fig. left).
4. Remove the insulating strip from the battery compartment. The teach-
in mode is automatically activated for three minutes.
The teach-in mode can be activated manually with the system key (see
„Device overview“ on page 21) for a duration of 3 minutes.
5. The device will be displayed automatically in the Alpha IP app.
6. For confirmation, enter the last four digits of the device number (SG-
TIN) or scan the supplied QR code. The device number can be found
below the QR code or in the battery compartment.
The LED will light up in green after a successful teach-in process. The
process must be repeated if the LED lights up in red.
7. Follow the directions of the app.
5.2 Installation
The battery operation allows a free choice of the installation place. The
device can be installed in the supplied interchangeable frame by fixing
the mounting plate with screws or with adhesive tape. An integration
into an existing switch series is also possible.
5.2.1 Installation with adhesive strips
Depending on the surface, installation can be performed with the sup-
plied double-sided adhesive tape or with the supplied screws. Installation