XRM2-CLINK-R-GIGE
User Manual
2 Installation
The XRM-CLINK-R-GIGE is designed to plug in to the front panel connector (SAMTEC QSH series) on the
FPGA base card. The retaining screws should be tightened to secure the XRM-CLINK-R-GIGE.
The XRM-CLINK-R-GIGE is designed to be used with Virtex 7 series cards and I/O voltages are set accordingly
Note:This operation should not be performed while the host PMC/XMC or PCI card is powered up.
2.1 Handling instructions
Observe precautions for preventing damage to components by electrostatic discharge. Personnel handling the
board should take SSD precautions.
Avoid flexing the board.
3 Specification
3.1 Connectors
SDR connector 3M part number 12226-8250-00FR
Standard RJ-45 connector
3.2 Mating Cableform
3.2.1 SDR connector
SDR cable assembly 3M part number 1SF26-L120-00C-XXX, where XXX= length in centimetres.
SDR to MDR cable assembly 3M part number 1MF26-L560-00C-XXX, where XXX= length in centimetres.
3.2.2 RJ-45 connector
Standard RJ-45 Cat 5e/6 cable.
3.2.3 Miscellaneous
RS232 transceiver controlled from FPGA implementing 3-wire interface. Connection via 3-pin 1.0 mm thru-hole
header.
3.3 Order Code
XRM-CLINK-R-GIGE
For further information please contact Alpha Data.
4 Related Documents
Camera Link Specification v1.1 (Automated Imaging Association)
CameraLink Technology Brief Available from http://www.baslerweb.com
Xilinx EDK documentation. http://www.xilinx.com/ise/embedded_design_prod/platform_studio.htm
Page 3
Related Documents
ad-ug-01288_v1_0.pdf
