ADM-XRC-7Z2 User Manual
V1.2 - 24th Feb 2020
2 PCB Information
2.1 Physical Specifications
Form Factor
Single Width XMC
Length (conduction-cooled)
143.75 mm
Width
74.0 mm
Height
10.0 mm
Weight (conduction-cooled)
TBD
Table 3 : Physical Specifications
2.2 Motherboard / Carrier Requirements
The 7Z2 is a single width XMC.3 mezzanine with P5 and P6 connectors.
The 7Z2 is compatible with either 5V or 12V on the "VPWR" power rail.
The Primary XMC connector, P5, is compatible with the XMC.3 (VITA 42.3) specification for PCI Express
applications.
The Secondary XMC connector, P6 is not compatible with XMC.3 or XMC.10 (GPIO). It is important to check
compatibility prior to installation. If in doubt, please contact Alpha Data for assistance.
IMPORTANT
It is important to check compatibility with the carrier card prior to installation.
The Secondary XMC connector, P6 has +5V (power) -/+6V (serial port) levels. It is not compatible with XMC.3
or XMC.10 (GPIO). It must not be connected to the Alpha Data ADM-EMC-II or ADM-XMC-II carrier cards.
Please contact Alpha Data for carrier card compatibility.
2.3 Power Requirements
The power dissipation of the board is highly dependent on the Target FPGA application. A power estimator
spreadsheet is available on request from Alpha Data. This should be used in conjunction with Xilinx™ power
estimation tools to determine the exact current requirements for each power rail.
Page 3
PCB Information
ad-ug-1273_v1_2.pdf
