6
ALMECO nv
Air and water technologies
Royennestraat 51, B-7700 Moeskroen
[email protected] - www.almeco.eu
5. EQUIPMENT ARRIVAL/INSPECTION
If there are any shortages, discrepancies or damage to your product upon delivery, please immediately contact Almeco.
6. SAFETY INFORMATION
•
Installation, commissioning and electrical installation should only be performed by trained service personnel and in
accordance with the latest IEE regulations.
•
This booth is supplied with an earth fixing at the back of the base section.
•
PLEASE USE THIS EARTH POINT IN ALL INSTANCES.
•
Designers, manufacturers or operators are responsible for proper and safe installation as well as for safe operation.
NEVER
USE THIS PRODUCT WITHOUT EXTRACTION CONNECTED.
•
Safety features e.g. inlet guards, are not to be dismantled, circumvented or made inoperative.
Before using the JetBlack Safety Cleaning Booth
Electrical Safety
•
The Booth supply cable should be checked for nicks and cuts. The cable should be regularly checked to ensure that it is in
good condition.
•
Ensure that the correct supply voltage is available. Check the rating plate below the isolator, on the back of the Booth,
before connection.
•
It is recommended that the unit be hard wired to an electrical supply that is surge protected and in compliance with local
codes.
•
Check the base Earth point (located at the rear) is in place and undamaged.
•
Check that any plugs are suitable, undamaged and connected.
•
The only serviceable part within the JetBlack Safety Cleaning Station is the filter element.
•
The only serviceable parts within the extractor are the filter collection bag, and the main canister filter.
General Safety
•
Don’t use a pressure washer or steam washer to clean the Booth, extractor or Cleaning Station.
•
Always switch off the main Booth electrical supply before cleaning and always isolate before servicing.
•
EAR, EYE & RESPIRATION PROTECTION SHOULD BE USED AT ALL TIMES WHILST OPERATING THE BOOTH.
•
Always direct air from the Cleaning Station away from your eyes, ears and face.
•
The Cleaning Station has a thermal shut-off device for safety purposes. Prolonged use may cause the unit to shut-off. In this
case, switch the unit off and wait for a few minutes before re-use.
•
Don’t remove any guarding or the flexible hose at any time.
•
Don’t allow objects to pass through the guard whilst the fan is rotating.
J
ET
B
LACK
S
AFET Y
- C
LEANING
B
OOTH
