6
SETTINGS
By long holding the program knob on the BPM screen this allow you to access various setting
parameter screens. These include:
6.1
Input: Clk
Sets the ’Clk’ input to either review a clocked pulse signal for external syncing or be an addi-
tional CV input.
6.1.1 EXT Clock PPQN
Defines the expected ’Pulses Per Quarter Note’ for external clocking. It is recommended you
keep this value at the default 24.
6.2
Input: Run
Defined the action of the ’Run’ Input. It can be set too;
•
RUN
expects a gate like signal which sets the clock running when high, stopped when
low. Recommended you use this when syncing as gives Pam a chance to ’pre sync’ -
connect to the Din Sync or (converted) MIDI clock run signal.
•
RESET
Resets a running Pam to initial step when a trigger pulse is received. Will also
cause Pam to automatically start and stop when an external clock is detected (at least
2 pulses before starting).
•
CV
Sets the ’Run’ input as an additional CV input that can be assigned to various output
parameters
6.3
UI Theme
Allows you to select a visual theme for the user interface.
6.4
Enc Hold Time
Sets the time for a ’held’ program knob to be registered.
6.5
Load Bank
Loads an entire bank (all 8 outputs).
6.6
Save Bank
Saves an entire bank (all 8 outputs).
18
