Alltech KEENAN MechFiber345, Руководство оператора

Страница: 46 / 82

7. Troubleshooting
7.1 General Troubleshooting
PROBLEM: SOLUTION:
1. Weighing display won’t work properly
Check section 7.2 on weighing.
2. VFC door does not move Check hydraulic hoses and that valves are open.
Check tractor hydraulic oil level.
Check ram condition and pins are secure.
3. VFC door drops during mixing
Insufficient hydraulic pressure – check spool valve on tractor or
fit non return valve in line.
Check ram for signs of leakage.
4. VFC door closes unevenly/sticks Rams operating out of sequence – operate door to fully open
position and hold level to allow oil by-pass the ram when fully
open and level door – Repeat on fully closed, until door is even.
5. Excessive shear bolt breakage Machine overloaded.
Driving chain too loose – check condition and adjust idler
springs.
Feed out too fast – open feed out door slowly at first then open
fully.
Turn paddle a few turns before opening the feed-out door to
avoid huge load on machine, especially after feed has settled in
body of machine.
Run machine slower.
For non-BaleBlend models never load bales directly down on
paddle in one go – always chop up into at least 4 pieces.
6. Noisy operation
Check drive system oil level
Check & adjust chain tension
Grease all tensioner pivot points
Check chain alignment.
7. Feed is not mixed properly Insufficient mixing time.
Loading materials in wrong order.
Not enough time given for chopping.
Overloading of machine.
8. Feed out is too slow Check condition of paddle rubbers.
Slow down tractor ground speed.
Reduce engine revs to give paddle more time to push material
into auger. Ensure material is fully chopped before unloading.
9. Horsepower requirement is too high Check body blades and top knife sharpness.
Machine overloaded.
BaleBlend tines may be set too low.
10. Machine is not chopping
Blades blunt.
Not enough material in body – not heavy enough – try adding
more material or in case of hay/straw add water or a fork of
silage to weigh it down.
Machine overloaded.
46
Revision A04 July 2018