AllSportSystems SUPERBAY 10W, Руководство по установке

Страница: 11 / 39

All SportSystems, Inc. © 2021
Step 1 - Build the frame
If hitting bay is closer than 6” to ceiling see APPENDIX B - BUILDING THE FRAME (For Low
Ceilings). Two persons recommended and use of a stepladder. Position eye bolts inward. Verify
correct width and depth when tightening connectors (may need to back poles slightly out of connectors
to reach correct dimension).
For bays greater than 10ft
wide, add extender poles
to each of the four width
poles using couplers.
Add two 3-ways to a width
pole to form the bottom
rear pole.
Insert two lower depth
poles into rear 3-ways to
form the frame bottom.
Insert two height poles
into rear 3-ways.
Add two 3-ways to the top
of the rear height poles
Insert top rear width pole
to complete the back of
the frame.
Insert two upper depth poles into the rear
top 3-ways.
Slide two T-Connectors* on each of the
upper depth poles.
For SkyRailPLUS™/SkyBridge™
T-Connectors are not used
Add two L-Corners to the bottom depth
poles.
Insert two front height poles into the
L-Corners.
Add two 3-Ways to the front height poles.
For SkyRailPLUS™
add two L-Corners instead.
Insert screen pole into the two
T-Connectors.
For SkyRailPLUS™/SkyBridge™
Use the SkyBridge™ bracket and
unistrut. See SkyBridge™
setup guide
for instructions on installing this pole.
Insert front width pole * into front 3-Ways.
For SkyRailPLUS™
Use the SkyBridge™ bracket and
unistrut. See SkyBridge™
setup guide
for instructions on installing this pole at
the front of the cage.
Page 11 of 39 Return to Table of Contents Last Revised 8/5/21