Introducing the SG-9500
1-2
SG-9500 Hardware Guide
1.1
Planning Your Deployment
This equipment is intended to be installed by trained service personnel and in
environments where access by unauthorized personnel is restricted (Restricted
Access Location). The SG-9500 complies with the requirements for operator access
when all cards and covers are in place.
Please note that the power resources used by the SG-9500 must be planned and
installed by a qualified electrical engineer only. Before installing or using the SG-
9500, please read all Safety Information carefully to avoid electrical hazards that
can result in injury or loss of equipment.
In addition, be aware that all network and power connections to the SG-9500 are
from the rear of the device so there must be adequate space behind the unit for
safe access at all times.
1.2
Packing List
Verify that the following items are included with the SG-9500:
•
Pair of AC power IEC-320 C13/C14 cables (included in the SG-9500 AC
version only)
•
Up to 24 x 1/10G SFP+ Optical Transceivers (either SR, LR, SX or LX5 Fiber)
or Copper transceivers.
OR
Up to 8 x 1/10 QSFP+ Optical Transceivers (either SR, LR, SX or LX5 Fiber)
or Copper transceivers and 4 x 100G QSFP28 Optical Transceivers.
•
2 x SFP+ Optical Transceivers (either SR Fiber or LR Fiber) for Management
Ports
NOTE All Transceivers MUST be provided or approved by Allot specifically for the SG-
9500. Any other Transceivers will not function in the SG-9500.
•
Ethernet cable straight CAT6 RJ45_2_RJ45 3m for management (Allot P/N
C243010)
Note Cables to connect from the Service Gateway to the Bypass are included with
the Bypass Unit. Cables to connect from the Bypass Unit to the Network are
not provided by Allot.