Allnet ALL168205NANO, Быстрое руководство по установке

Страница: 3 / 11

ALL168205 NANO Quick Installation © 2012 ALLNET GmbH All rights reserved Page 3
I
MPORTANT
S
AFETY
I
NSTRUCTIONS
This product is intended for connection to the AC power line. For installation instructions, refer to the Installation
section. For removing the device, refer to the Unplug section. The following precautions should be taken when using
this product.

Please read all instructions before installing and operating this product.

Please keep all instructions for later reference.

Please follow all warnings and instructions marked on the product.

Unplug the AC coupler from the wall outlet before cleaning. Use a damp cloth for cleaning. DO NOT
use liquid cleaners or aerosol cleaners
.

DO NOT operate this product near water.

This product should never be placed near or over a radiator, or heat register.
 This product relies on the building’s electrical installation for short-circuit (over current) protection.

Ensure that a fuse or circuit breaker no larger than 120 VAC 20A or 240 VAC 16A is used on the phase
conductors (all current-carrying conductors).

DO NOT allow anything to rest on the product interconnect cords.

DO NOT locate this product where people may walk on the cords.

Because the 200Mbps PLC Ethernet Bridge product sends data over the powerline, it is recommended that
you plug it directly into a power outlet. Do not plug the device into a UPS or power strip with surge
protection. The 200Mbps PLC Ethernet Bridge product has its own power filter for protection against surges.

The product can be operated at an ambient temperature of max. 40
℃
.

For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily
accessible.

Only a qualified technician should service this product. Opening or removing covers may result in exposure to
dangerous voltage points or other risks. In any case of opening, warranty for the product will be lost.

Unplug the AC coupler from the wall outlet and refer the product to qualified service personnel for the following
conditions:

When the interconnect cords are damaged or frayed.

If liquid has been spilled into the product.

If the product has been exposed to rain or water.

If the product does not operate normally when the operating instructions are followed.

If the product exhibits a distinct change in performance.