ADSL2/2+ Broadband Router User Guide
Data - VPN-Auto Policy Screen
General
Policy Name
Enter a unique name to identify this policy. This name is not
supplied to the remote VPN endpoint. It is used only to help you
manage the policies.
Remote VPN
Endpoint
If the remote endpoint has a dynamic IP address, select "Dynamic
IP address". No "Address Data" input is required.
Otherwise, select the desired option (IP address or Domain Name)
and enter the address of the remote VPN endpoint you wish to
connect to.
Note:
The remote VPN endpoint must have this VPN Gateway's
address entered as its "Remote VPN Endpoint".
NetBIOS Enable
Check this if you wish NETBIOS traffic to be forwarded over the
VPN tunnel. The NETBIOS protocol is used by Microsoft
Networking.
Local LAN
Local LAN
This identifies which PCs on your LAN are covered by this policy.
For each selection, data must be provided as follows:
•
Single address
Enter an IP address in the "IP address" field. Typically, this
setting is used when you wish to make a single Server on your
LAN available to remote users.
•
Subnet address
Enter an IP address in the "IP address" field, and the desired
network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses entered as
its "Remote" addresses.
Remote LAN
Remote LAN
This identifies which PCs on the remote LAN are covered by this
policy. For each selection, data must be provided as follows:
•
Single PC - no subnet
Select this option if there is no LAN (only a single PC) at the
remote endpoint. If this option is selected, no additional data is
required.
•
Single address
Enter an IP address in the "IP address" field. This must be an
address on the remote LAN. Typically, this setting is used
when you wish to access a server on the remote LAN.
•
Subnet address
Enter an IP address in the "IP address" field, and the desired
network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses entered as
its "Local" addresses.
60
