27
39
39
40
41
39
39
18
12
9. Power supply interruption
10. Adjusting the track roller height
Condition of device prior to mains
interruption
Duration of power
supply interruption
Condition of device after
mains
interruption
Drive and heating are switched on (welding
process).
≤ 5 sec.
The device continues running without
a restart safeguard with the same set-
tings as before the interruption.
The drive and heating are switched on
(welding process).
> 5 sec.
The device starts up and the start
display appears on the display.
The device is not in the welding process.
-
The device starts up and the start
display appears on the display.
The chassis height can be increased or reduced by adjusting the
track rollers at the front (18)
and rear (12)
.
A.
Undo and remove the
cylinder screws (39)
with a socket wrench (wrench size 5 mm).
B.
Set the
front roller holder (40)
and the
rear
roller holder (41)
to the desired height.
C.
Tighten the
cylinder screws (39)
with a socket
wrench (wrench size 5 mm).
Risk of burning!
Before dismantling, it must be ensured that the welding wedge has cooled down, the device has
been switched off with the main switch (2), and the power cord is disconnected from the mains.
