Allied Ho-Pac NT8900 Series, Техническое руководство

Страница: 22 / 46

SECTION 7.0
CARRIER APPLICATION
The Allied NT8900 Ho-Pac is designed
for use and installation on medium to
large rubber tire backhoe loaders and
small excavators. Typically, carriers
weigh 9,000 to 30,000 lbs (4,000 to
14,000 kg). The carrier must have
adequate lift and hydraulic capacities to
properly and safely operate the Ho-Pac.
Refer to the specifications in Section 4.0.
An Allied installation kit is
recommended to properly install the Ho-
Pac. Allied installation kits are
specifically designed for each carrier.
Each kit contains the proper mechanical
and hydraulic components for optimum
Ho-Pac performance.
Allied hydraulic kits utilize the Allied
“AC” series valves. The “AC” series
solenoid-operated valve provides
regulated, priority flow at a controlled
pressure.
Always follow hydraulic kit installation
instructions. Carrier hydraulic circuit
designs differ and damage to the Ho-Pac
or carrier may result if the hydraulic kit
is improperly installed. Contact Allied
for installation recommendations.
While the Ho-Pac is designed to
minimize the vibrations induced into the
carrier, the operator must be isolated
from excessive vibrations should they
occur. Refer to the carrier’s manual for
specific information regarding vibration
isolation of the operator’s compartment
or seat.
The new Variable Mounting System
provides mounting versatility. The Ho-
Pac can be easily adapted to match the
stick/link dimensions and pin sizing of
most carriers; and to accommodate many
quick couplers that grab pins.
7/21/03 18