Allied Telesis x510-28GPX, Справочник по командам

Страница: 2320 / 2822

C613-50170-01 Rev B Command Reference for x510 Series 2320
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
A
LLIED
T
ELESIS
M
ANAGEMENT
F
RAMEWORK
™ (AMF) C
OMMANDS
DEBUG ATMF PACKET
debug atmf packet
Overview This command configures AMF Packet debugging parameters. The debug only
displays information relevant to the current node. The command has following
parameters:
Syntax
debug atmf packet [direction {rx|tx|both}] [level {1|2|3}]
[timeout <
seconds >] [num-pkts < quantity >]
[filter {node < name >|interface < ifname >}
[pkt-type [1][2][3][4][5][6][7][8][9][10][11][12][13]]]
Simplified
Syntax
NOTE
: You can combine the syntax components shown, but when doing so, you must
retain their original order.
Default Level 1, both Tx and Rx, a timeout of 60 seconds with no filters applied.
NOTE
: An alias to the no variant of this command - undebug atmf - can be found
elsewhere in this chapter.
Mode User Exec and Global Configuration
Usage If no additional parameters are specified, then the command output will apply a
default selection of parameters shown below:
debug atmf packet [direction {rx|tx|both}]
[level {[1][2|3}]
[timeout <
seconds >]
[num-pkts < quantity >]
debug atmf packet filter [node < name >]
[interface < ifname >]
[pkt-type
[1][2][3][4][5][6][7][8][9][10][11][12][13]]
Parameter Description
direction
Sets debug to packet received, transmitted, or both
rx
packets received by this node
tx
Packets sent from this node
1
AMF Packet Control header Information, Packet Sequence
Number. Enter 1 to select this level.
2
AMF Detailed Packet Information. Enter 2 to select this level.
3
AMF Packet HEX dump. Enter 3 to select this level.
timeout
Sets the execution timeout for packet logging