C613-50170-01 Rev B
Command Reference for x510 Series
2091
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
V
IRTUAL
C
HASSIS
S
TACKING
(VCS
TACK
™) C
OMMANDS
STACK
MANAGEMENT
SUBNET
stack management subnet
Overview
This command configures the subnet address used by the stack management
VLAN.
Use the
no
variant of this command to reset the stack’s VLAN subnet management
address back to the default address and mask (192.168.255.0/27).
Syntax
stack management subnet <
ip-address
>
no stack management subnet
Default
The default stacking management VLAN subnet address is 192.168.255.0 with a
subnet mask 255.255.255.224 or /27.
Mode
Global Configuration
Usage
This command configures the stack management VLAN subnet address.
The management VLAN will be used for high speed communication between
stacked units via the stacking ports. Although this command enables you to
change the IP address command, the subnet mask must always remain as shown.
The stack management IP subnet is solely used internally to the stacked devices,
and cannot be reached external to the stack. You should only change the stack
management VLAN subnet address if it causes a conflict within your network.
Note that several separate stacks can use the same default management VLAN
subnet address even though their user ports may share the same external network.
If the stack subnet address is changed, then the configuration for any new units
must also be updated before they are inserted into the stack.
If the management VLAN subnet address is changed by this command, you can
use the
no
variant of this command to reset it to its default.
Example
To set the management VLAN subnet address to 192.168.255.144:
awplus#
configure terminal
awplus(config)#
stack management subnet 192.168.255.144
Related
Commands
Parameter
Description
<ip-address>
The new subnet address for the stack management VLAN.
