C613-50170-01 Rev B
Command Reference for x510 Series
1357
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
PIM-SM C
OMMANDS
SHOW
IP
PIM
SPARSE
-
MODE
INTERFACE
show ip pim sparse-mode interface
Overview
Use this command to show PIM-SM interface information.
For information on filtering and saving command output, see the
with AlliedWare Plus” Feature Overview and Configuration Guide
Syntax
show ip pim sparse-mode interface
Mode
User Exec and Privileged Exec
Example
To display information about PIM-SM interfaces, use the command:
awplus#
show ip pim sparse-mode interface
Output
Figure 33-4:
Example output from
show ip pim sparse-mode interface
Total configured interfaces: 16 Maximum allowed: 31
Total active interfaces: 12
Address Interface VIFindex Ver/ Nbr DR DR
Mode Count Prior
192.168.1.53 vlan2 0 v2/S 2 2 192.168.1.53
192.168.10.53 vlan3 2 v2/S 0 2 192.168.10.53
... Note that this screen has been edited to remove any additional interfaces.
Table 1:
Parameters in the output from the
show ip pim sparse-mode interface
command
Parameters
Description
Total configured
interfaces
The number of configured PIM Sparse Mode interfaces.
Maximum allowed
The maximum number of PIM Sparse Mode interfaces that
can be configured.
Total active
interfaces
The number of active PIM Sparse Mode interfaces.
Address
Primary PIM-SM address.
Interface
Name of the PIM-SM interface.
VIF Index
The Virtual Interface index of the VLAN.
Ver/Mode
PIM version/Sparse mode.
Nbr Count
Neighbor count of the PIM-SM interface.
