Allied Telesis IE340 Series, Руководство по установке, Страница: 90 / 136

IE340 Series Installation Guide
90
Installing SFP Transceivers
Please review the following guidelines before installing SFP transceivers:

SFP transceivers are hot-swappable. You may install them while
the device is powered on.

For a list of supported transceivers, refer to the product data sheet.

The operational specifications and fiber optic cable requirements
of the transceivers are provided in the documents included with the
devices.

You should install a transceiver before connecting its fiber optic
cable.

Fiber optic transceivers are dust sensitive. Always keep the plug in
the optical bores when a fiber optic cable is not installed, or when
you store the transceiver. When you do remove the plug, keep it
for future use.

Unnecessary removal and insertion of a transceiver can lead to
premature failure.

Installing or removing a transceiver from a slot in the switch might
require slightly more force than typically required with other
network equipment. This is because of the design of the SFP
cages.

When you use an SFP module, Allied Telesis recommends leaving
the adjacent copper port
unused
. When an SFP slot and its right-
side copper port are used, the space between the SFP module and
port cable is so limited that disconnecting the cable is difficult. See
Figure 13 on page 62.
Be aware of the space issue and use a flat tool to disconnect the
port cable if you decide to use both SFP slot and copper port next
to each other.
Warning
A transceiver can be damaged by static electricity. Be sure to
observe all standard electrostatic discharge (ESD) precautions,
such as wearing an antistatic wrist strap, to avoid damaging the
device.
 E86
The illustrations in the following procedure show a transceiver with a
duplex LC connector. The connectors on your transceivers may be
different.
To install SFP transceivers in the chassis, perform the following
procedure: